Description
Shake before use and follow the instruction below :
- Locate the two black rubber fuel lines that go to the injection pump.
- With the lines removed, insert one of the plastic fuel line adapters you received into each of the rubber lines.
- Open the can of DP, being careful not to spill it. Place the two lines into the can, and put the can in a safe spot on the engine where it will not tip over. If you can have a helper hold the can, at least initially, that is ideal. Note that as you run off the can, the can will get HOT so make sure your helper is holding the can with a cloth or gloves. Ensure that the lines are at the bottom of the can, where they will not suck air as the can empties.
- Go inside the car and start the engine. Let the engine idle for the next five minutes. After that, your goal is to run the engine through various engine speeds (RPMs). I like to run it for a few minutes at 1500rpm, then 2000rpm, and so on, going all the way up to around 3500rpm at constant throttle
Transportation | Storage | Handling
Not regulated for Transportation & Storage
Handling – Refer to warning label on containers. Normal precautions for industrial chemicals apply.
Characteristics of GCM – IC 1207
- Easy to apply
- User friendly
- Flammable
- Regulations on transport and storage
Caution :
- Remove victim to fresh air and keep at rest in a position comfortable for breathing.
- Flush contaminated skin with plenty of water.
- Immediately flush eyes with plenty of water.
- Wash out mouth with water. Remove dentures if any.
- Keep away from childrens
Reviews
There are no reviews yet.